A slight diversion today as finishing the story of the 250 build is way overdue. So some words and pictures of painted bits, metal bits and a nice piece of leather.

With three coats of base black applied, a series of white stripes were then masked and added. Everything was left for a couple of days to harden up before a very fine rub over with extra fine paper prior to the lacquer going on. For reasons of cost more than anything I’d elected to use rattle can lacquer rather than 2-pack on all parts apart from the fuel tank, which would be treated to a good couple of coats of petrol resistant lacquer, again from a rattle can. In retrospect I wish I’d gone the 2-pack route but it made the whole paint phase way too expensive, the petrol proof stuff works well but has yellowed in places and was quite tricky to apply evenly. With the lacquer all hardened it was time for a good polish and I can’t recommend Autoglym Super Resin Polish enough. Fantastic stuff and everything was just so shiny shiny.

Two important pieces of metalwork remained to be fabricated as all the painted parts made their way onto the bike for the final assembly. I knew the area at the back of the seat needed tidying but hadn’t been able to do much about it without the seat so it was stroke of luck that the seat arrived back just in time from being recovered. The first task was to make a piece to shut off the open area between the new mudguard and the seat mounting assembly. this then wrapped over the seat mount and formed an infill sitting below the rear of the seat base moulding.As before I worked it all out with thin card first which meant I could create a pretty accurate template for marking and cutting the sheet steel which was cut flat and then bent up in the bench vice.

For ages I’d been wondering how to finish off the rear of the seat. Knowing that there would have to be some kind of cover plate didn’t seem enough, there needed to be something else in there to give a more finished look. The answer came to me out cycling one day when I spotted and old bicycle with a little pouch hung from the back of the saddle. I ventured onto the internet to see what I could find for motorcycles. As it turned out, not too much unless I wanted something that looked like it had fallen off the back of John Wayne’s horse, and tassels are definitely not my thing. Taking the bicycle route proved more fruitful and in a fit of extravagance I splashed out on this lovely little number from Brooks the saddle makers. I quickly made up an angle bracket to fix the panel to, mounted to the seat base, and again using some card drew around the profile of the seat and transferred it to another template for cutting. A couple of holes and two slots later I had a neat little cover panel that the pouch straps attached to directly.

With these two new parts painted black final assembly could continue apace, my deadline for borrowing the workshop was looming.